Injector Stanley Meyer
TO GET THE NON THERMAL EXPLSOIVE EFFECT 2x TNT 2 x HHO, YOU MUST MAKE SURE NOT TO GROUND YOUR WATER OR NANO BUBBLES in the Nano Bubble Water OF H2 O2. MAny have tried putting steam water through inject the only water that works is positive charge groudn injector and nano bubble water fuel
can I just ask you something?
A spark plug has about 4000 ohms impedance but I don't think your VIC has no where near that, i've been using capacitive reactance calculators and such trying to work out how you tuned the VIC to the spark plug.
How did you match the capacitive and inductive reactance of the VIC to the spark plug and did you also have to narrow the spark gap?
Did you use any resistive or capacitive elements in the impedance matching network or was it more to do with frequency?
OK so when we move onto an open ended transmission line i.e a tube set either in parallel or series and the resistive element is no longer present (plasma ark of spark plug) would it be fair to assume in order to get an impedance match anywhere near to the VIC we would at least need to add a parallel element of resistance at the far point? See picture.
The reason why i've asked this is because using capacitance/reactance calculators there is absolutely no way you can tune the tubes capacitive and inductive reactance to the VIC unless you had tubes that were 15 feet long unless you had a dielectric gap in the tubes that was .00050 of a mm.
Unless of course the two chokes themselves match the inductive and capacitive reactance of the cell in which case you would need multiple tap points along one of the chokes.
here we see three systems, the first one is co-linear, on that transmission line each driven element counts as resistance in the line and the capacitor between acts as a go between and balances the reactance.
The shunt fed antenna uses a dc ground where capacitance is negligible and doesn't affect the inductance so we can tap the 50 ohm point from the tuning coil.
The last one is Stan's, are we saying that because of a massively low dielectric constant that we can tap the 192 Ohm point of the secondary from one of the chokes because of negligible capacitance?
It is expected that Stan Dissolved gases into the water ( like how a fish get o2 out) see japan techno
it is expected Stan Vacuumed through injector
it is expected the tank was pressurized and vented gas and cooled water returning from injectors.
These Drawing and Parts are Available now
Stan Meyer Injector Update. Machinable Glass Ceramic is here and going out to the man who will Finish machining The Injector. You can find this part here: https://www.mscdirect.com/product/details/31959745?item=31959745